Piston clip installation tool for C-shaped circlips on your moped, moped and small motorcycle.
This tool enables the installation of 10 mm piston pin circlips without eyelets, also known as C-clips, without causing damage to the piston or causing them to fly off.
The locking clip is first inserted into the conical part (bushing) of the tool from behind. The pin is then attached and held against the bore of the piston pin on the piston. The long cylinder can then be carefully pressed into the groove. The use of some lubricant can be helpful.
The suitable alternative for 12 mm KoBo retaining clips can be found in the accessories section.
Quality product from the manufacturer Naraku.
| Ø Pin | 4.5 mm |
| Diameter | 10 mm |
| Manufacturer | Naraku |
| Material | Steel |
| Surface | burnished |
| Total length | 134 mm |
| Area of application | (Dis)assembly tool |
Ratings
Accessories & related products
Explore categories from Tools
Moped fans also bought
Speedometer drive 16" left with lubrication hole
Ø mounting hole: 11.2 mm · Material: Aluminum · Place of use: left · Color: gray · Wheel size: 16 " · Ø axle: 11 mm · 4-edge speedometer cable: 1.8 mm · Overall width outside: 48 mm · Ø outside: 42 mm · Total height: 52 mm · Thread type: MF10x1 (fine pitch thread)
EUR 25,00
Hot 
swiing® ingenious "Expert" motor stand
Manufacturer: swiing® ingenious parts · Material: Steel · Surface: varnished · Ø Receptacle: 25 mm · Ø Receptacle: 35 mm · Color: red · Color: white · Total length: 370 mm · Width: 245 mm · Hole spacing: 21.5 mm · Material thickness: 3.5 mm · Area of application: Motor bracket · Height: 340 mm
EUR 85,60
Collection only possible with online purchase and appointment.
